Version

    ParallelPartition

    Short Description
    Ports
    Metadata
    ParallelPartition Attributes
    Details
    Compatibility
    See also

    Short Description

    ParallelPartition distributes incoming data records among different CloverDX Cluster workers. The algorithm of the component is derived from the regular Partition component.

    ComponentSame input metadataSorted inputsInputsOutputsJavaCTLAuto-propagated metadata
    ParallelPartition
    yes
    no
    11[1][2][2]
    yes

    [1]  The single output port represents multiple virtual output ports.

    [2]  ParallelPartition can use either a transformation or two other attributes (Ranges and/or Partition key). A transformation must be defined unless at least one of the attributes is specified.

    Ports

    Port typeNumberRequiredDescriptionMetadata
    Input0
    yes
    For input data recordsAny
    Output0
    yes
    For output data recordsInput 0

    Metadata

    ParallelPartition propagates metadata in both directions. The component does not change priority of propagated metadata.

    The component has no metadata templates.

    The component does not require any specific metadata fields on its ports.

    ParallelPartition Attributes

    ParallelPartition has same attributes as Partition. See Partition Attributes.

    Details

    ParallelPartition distributes incoming data records among different CloverDX Cluster workers.

    The algorithm of this component is derived from the regular Partition component. For more details about attributes and other component specific behavior, see the Partition component.

    If the Ranges attribute is used for partitioning, the number of defined ranges must match the allocation of the following component. Use the Add and Remove toolbar buttons to adjust the number of defined ranges:

    This component belongs to a group of Cluster components that allows the change from a single-worker allocation to a multiple-worker allocation. So the allocation of the component preceding the ParallelPartition component has to provide just a single worker. The allocation of the component following the ParallelPartition component can provide multiple workers.

    [Note]Note

    For more information about this component, see Chapter 42, Data Partitioning in Cluster.

    Compatibility

    VersionCompatibility Notice
    3.4The component is available since version 3.4.
    4.3.0-M2ClusterPartition was renamed to ParallelPartition.